The electrical connectionsA replacement cover/carrier must be obtained from
your local Tricity Bendix Service Centre whose ad-
WARNING: THIS APPLIANCE MUST BE EARTHED.
dress is listed in the Customer Care Booklet which ac-
The manufacturer declines any liability should thiscompanies your instruction manual.
safety measure not be observed.
This appliance complies with the E.E.C. Directive
If the plug that is Ţtted to your appliance is not suita-No. 87/308 of 2.6.87 relative to radio interference
ble for your socket outlet, it must be cut off and thesuppression.
appropriate plug Ţtted.
This appliance complies with the following
Remove the fuse from the cut off plug.E.E.C. Directives:
The cut off plug should then be disposed of to prevent-73/23 EEC of 19.2.73 (Low Voltage Directive) and
the hazard of shocks in case it should be plugged intosubsequent modiŢcations;
a 13amp socket in another part of your home.-89/336 EEC of 3.5.89 (Electromagnetic Compatibil-
ity Directive) and subsequent modiŢcations.
Important
Please ensure that when the appliance is installed
The wires in the mains lead are coloured in accord-
it is easily accessible for the engineer in the event
ance with the following code:
of a breakdown.
Green and Yellow- Earth
Blue- Neutral
Brown- Live
If you Ţt your own plug, the colours of the wires in the
mains lead of your appliance may not correspond with
the markings identifying the terminals in your plug,
proceed as follows:
Fig. 1
GREEN & YELLOW
13 AMP. FUSE
13 AMP
BROWN
BLUE
D207CORD CLAMP
Connect the Green and Yellow (earth) wire to the ter-
minal in the plug which is marked with the letter �EE or
the earth symbol , or coloured green and yellow.
Connect the blue (neutral) wire to the terminal in the
plug which is marked with the letter �NE or coloured
black.
Connect the brown (live) wire to the terminal in the
plug which is marked with the letter �LE or coloured
red.
The plug moulded onto the lead incorporates a fuse.
For replacement, use a 13amp BS1362 fuse. Only
ASTA or BSI approved fuses should be used.
The plug must not be used if the fuse cover/carrier is
lost. The cover/carrier is indicated by the coloured in-
sert at the base of the plug.
6 |
ACEC
